GATTAquant microscopy standards
February 13, 2015 at 5:27 pm | sam | review, single moleculesJürgen Schmied from GATTAquant came by the other day and let me play around with some of their cool DNA origami fluorescence standards.
The PAINT sample was really cool. It has short oligos on the DNA origami and complementary strands labeled with dyes in solution. The binding/bleaching kinetics are such that each hotspot blinks many times during an acquisition. After a quick 10,000 frame acquisition over 3 min, we collected a dataset that we could easily get a super-resolution image. We used ThunderSTORM to fit the data and correct for drift. But without any other corrections, we could easily resolve the three PAINT hotspots on each DNA origami:
But my favorite sample was actually the confocal test slide. It had two sets of dyes about 350 nm apart permanently labeled on each DNA origami.
This let me test the resolution and image quality using different configurations on our Diskovery confocal/TIRF system.
Each spot contained only about 4-8 dyes. So it was a much greater challenge to our microscope than TetraSpeck beads.
I highly recommend GATTAquant test samples. Very fun.
UPDATE: Jürgen ran my data though GATTAquant’s analysis software and sent me the results below.
3 Comments »
RSS feed for comments on this post. TrackBack URI
Leave a comment
Powered by WordPress, Theme Based on "Pool" by Borja Fernandez
Entries and comments feeds.
Valid XHTML and CSS.
^Top^
~cost?
Comment by LLL — February 16, 2015 #
300 Euros, I think?
Comment by sam — February 16, 2015 #
Hey Sam, would I be able to get a copy of the raw data you acquired on the Diskovery? I might be able to convince the bosses about getting one of these test slides if I had that. Thanks!
Comment by John Oreopoulos — April 4, 2015 #